본문 바로가기

FAQ

02

Support

FAQ
ALARM TROUBLESHOOTING MANUAL
281 Results
A
  • Cause

    Minimum Level is lower than the Level of the measured load value is set.

  • Solution

    The next time the Cycle Start signal. Load is lower than the value set is not a processing tool breakage, so the next time the processing load is judged equipment operation. You must check the condition of the minimum level of fire if necessary, the Data

A
  • Cause

    MAIN SPINDLE GEAR Oil level Low

  • Solution

    MAIN SPINDLE GEAR OIL, please determine the amount of the supplement.

A
  • Cause

    SIDE DOOR AUTO CLOSE command but did not signal the door fastened.

  • Solution

    In the way that K7.3 = 1 after the command TIMER 23 is completed and failed to detect the SENSOR signal to CLOSE within two seconds.

A
  • Cause

    Planetary gear attempts to convert, but failed.

  • Solution

    Please check the action of the planetary gear

A
  • Cause

    Main spindle temperature high!

  • Solution

    Spindle stop Please check the status of the action of the oil cooler.

A
  • Cause

    Main spindle temperature high!

  • Solution

    Spindle stop Please check the status of the action of the oil cooler.

A
  • Cause

    Alarm has occurred in the servo turret amp.

  • Solution

    Electric maintenance manual Appendix "E" Please check your Alarm Amp Beta.

A
  • Cause

    Alarm has occurred in the servo turret amp.

  • Solution

    Elec.BOX, please replace the BATTERY on the inside of the Beta Amp.

A
  • Cause

    AUTO POWER OFF READY!

A
  • Cause

    Work had to be completed, operating ejector signal did not receive.

  • Solution

    Please check the forward and reward sensor signals

A
  • Cause

    13-24 in each location, MILL SPINDLE rotation command cannot be

  • Solution

    After the REST, please turn in a LIVE TOOL position dictates

A
  • Cause

    Gear COOLATNG OIL flow ALARM on the device to make sure this happened.

  • Solution

    GEAR OIL for cleaning the FILTER attached to the COOLAER and then back again, please verify the health and status of the ALARM. If you're having an alarm FILTER replacement or back if OIL flows.

A
  • Cause

    It indicates that error is detected while measurement of thread groove.

  • Solution

    This signal becomes "1" under the following condition: (This signal becomes "1" when the groove of thread measurement completion signal GTMC becomes "1" at the same time.) - The groove of thread is measured when axes except for PMC axis, and spin

A
  • Cause

    RE-MACHINING THREAD MODE

A
  • Cause

    The tool is broken.