본문 바로가기

FAQ

02

Support

FAQ
ALARM TROUBLESHOOTING MANUAL
281 Results
A
  • Cause

    Mode to decide Position of S/R base #1 is operated. Press spindle stop button to operate PIN.

  • Solution

    Set K10.3 at ‘0’.

A
  • Cause

    Hydraulic switch did not operate when LUB. PUMP for 3-step gear started.

  • Solution

    Check for operation of pump or amount of hydraulic oil.

A
  • Cause

    Counter completion signal of tool lifetime control is detected.

  • Solution

    Reset counter in tool management page.

A
  • Cause

    In PST mode, press PST button to set work offset that considered tool offset of the tool selected at G54 Z AXIS.

  • Solution

    Press ‘PSM’ button to cancel it.

A
  • Cause

    In PST mode, press PST button to set work offset that considered tool offset of the tool selected at G55 Z AXIS.

  • Solution

    Press PSM button to cancel it.

A
  • Cause

    Pneumatic pressure supplied to the machine is lowered below designated pressure.

  • Solution

    Check for pressure at pneumatic line. In case of machine that uses no pneumatic pressure, check if K5.0 is set at '0'.

A
  • Cause

    Synchronization ERR is larger than value set at 4811 during spindle SYNCHRONOUS CONTROL.

  • Solution

    Check for setting value at NC parameter #4811 and check for ERR amount during spindle SYNCHRONOUS CONTROL.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.1

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.1 and reset counter.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.2

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.2 and reset counter.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.3

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.3 and reset counter.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.4

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.4 and reset counter.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.5

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.5 and reset counter.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.6

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.6 and reset counter.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.7

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.7 and reset counter.

A
  • Cause

    Reached at setting value at external TOOL COUNTER NO.8

  • Solution

    Replace rotating tool post tool set at TOOL COUNTER NO.8 and reset counter.