본문 바로가기

FAQ

02

Support

FAQ
ALARM TROUBLESHOOTING MANUAL
281 Results
A
  • Cause

    Number of NC process parts (NC parameter #6711) reached at number of required parts (NC parameter #6713).

  • Solution

    RESET quantity at #6711 and press RESET button for ALARM RESET.

A
  • Cause

    Chuck pressure change command (M71, M72) is given during main spindle rotation.

  • Solution

    Chuck pressure change command (M71, M72) is given during main spindle rotation.

A
  • Cause

    MAIN SPINDLE gave spindle rotation command in neutral status.

  • Solution

    Give M41 ~ 43 command not in neutral position to run spindle command.

A
  • Cause

    Phase shift for Spindle synchronous control mode.

  • Solution

    Push Reset button.

A
  • Cause

    AUTO TOOL PRESETTER ARM is working but failed to detect sensor in the time limit.

  • Solution

    Check for sensor or motor. If the ARM operates, check if the confirmation sensor signal is input.

A
  • Cause

    operated the STEADY REST #2 during the spindle rotation

  • Solution

    Please operating STEADY REST #2 after the spindle stop.

A
  • Cause

    operated the STEADY REST#2 but sensor can’t detect.

  • Solution

    please check the STEADY REST #2 input switch operation.

A
  • Cause

    Commanded external output M CODE(M201~208), but the end signal is not detected within 10 seconds.

  • Solution

    Check the end signal corresponding to external M code. When it does not exist, set PMC parameter D52 items to ‘no signal.’

A
  • Cause

    In MANUAL HANDLE INTERRUPT MODE

  • Solution

    Turn off the MANUAL HANDLE INTERRUPT MODE from GUI

A
  • Cause

    The preset SPINDLE LOAD is exceeded.

  • Solution

    Change the cycling condition or enhance the 4027 limit.

A
  • Cause

    S/R Base #2 Unclamp when moved beyond the Set point in D1300

  • Solution

    [JOG], [RPD] mode, the Z-axis reverse direction move it.

A
  • Cause

    S/R Base #2 Unclamp when moved beyond the Set point in D1304

  • Solution

    [JOG], [RPD] mode, the Z-axis forward direction move it.

A
  • Cause

    M279(S/R Base #2 Unclamp), M278(S/R Base #2 Clamp) was not completed within 30 seconds.

  • Solution

    1. After M Code command when Z axis don't moved to S/R Base #2 combined position : S / R Base # 2 is not correct position. please initialization of the location of S/R Base #2. 2. When z axis combination pin of S/R Base #2 does not work after z axis trans

A
  • Cause

    Other than [ZRN] Mode, during the S / R Base # 2 Uclamp, even though the Clamp has not command, it was Clamp,

  • Solution

    1. If Pin is combined with the Z axis, Please check the signal of the checking position Limit switch(X10.0, X10.1) of Pin 2. If Pin has not combined with the Z axis, please check the hydraulic working.. After turn off the alarm, please S/R Base #2 positi

A
  • Cause

    PROG '' S/R BASE # 2 has been tasked by the INTERLOCK M 279. T/S and PROG PROG ' S/R BASE # 1, please make sure that the CLAMP.

  • Solution

    Check below: - X axis is in orientation. - All Spindles stop - Door closes when Door Interlock Key S/W is on - PROG' T/S Base Clamp Check - PROG' S/R Base Clamp Check