본문 바로가기

FAQ

02

Support

FAQ
ALARM TROUBLESHOOTING MANUAL
281 Results
A
  • Cause

    Operation of Overload Relay due to Overload of BED cutting oil motor.

  • Solution

    Reset Overload Relay for BED cutting oil motor.

A
  • Cause

    Operation of Overload Relay due to Overload of slide way GEAR lubricant motor.

  • Solution

    Reset Overload Relay for slide way GEAR lubricant motor.

A
  • Cause

    In case of spindle manual rotation command after changing from auto mode to manual mode, spindle override switch is not at 1% position.

  • Solution

    Lower override switch to 1% and give spindle command.

A
  • Cause

    TURRET rotation command is given when X AXIS is not at zero point

  • Solution

    Give tool post rotation command after X AXIS zero return

A
  • Cause

    BATTERY replacement signal comes in CNC.

  • Solution

    Replace BATTERY FOR CNC in power input status.

A
  • Cause

    Voltage of BATTERY for servo encoder is LOW.

  • Solution

    Replace BATTERY for servo AMP in power input status

A
  • Cause

    Voltage of BATTERY for servo encoder is ‘0’.

  • Solution

    Replace BATTERY for servo AMP in power input status

A
  • Cause

    Main spindle rotation command is given when main chuck is not Clamped.

  • Solution

    Do chuck CLAMP and cycle start.

A
  • Cause

    100% of rapid feed rate is selected when zero point is not secured.

  • Solution

    Secure zero point and then select rapid feed rate 100%.

A
  • Cause

    JOGGING command is given to spindle, but the relevant spindle in the rotation command.

  • Solution

    The relevant spindle check for stop status and give command. spindle이 HOLD status considered as spindle rotation command.

A
  • Cause

    TOOL PRESETTER ARM is lowered during process in AUTO MODE or CYCLE START command is given in arm down status.

  • Solution

    Raise TOOL PRESETTER Arm for run cycle start or change to manual mode to RESET it.

A
  • Cause

    PRESETTER ARM is lowered during MANUAL MODE but axis traverse command is given when it is not in PST mode.

  • Solution

    Change to PST mode and do axis feed or raise PRESETTER ARM if PST mode is not going to be used.

A
  • Cause

    spindle rotation command is given in TOOL PRESETTER ARM down status or ARM is lowered during spindle rotation.

  • Solution

    For spindle rotation, raise TOOL PRESETTER ARM and rotate spindle.

A
  • Cause

    Tried PSM/PST mode when it is not in zero point security status of each axis.

  • Solution

    Run PSM/PST mode after manual zero return of each axis.

A
  • Cause

    AUTO DOOR CLOSE command is not given but no door close signal.

  • Solution

    TIMER 23 completes after K7.3=1 type command and CLOSE SENSOR signal is not detected in 2 seconds.