FAQ

reset mode for the position of base. For more information, please refer to maintenance in 3.7.2 reset of position coordinate of programmable steady rest base. The mode is on to decide the location of headstok base #2. PIN can be operated by pushing Spin

Set K10.7 ‘0’

M codes that cannot be commanded at the same block are commanded. M CODE GROUP 01 (M3/4/5/13/14/15/19/39/40/41/42/43/44/45/46/51/53/103/104/105/119) M5 can only be applied when K2.3=0, and M53 when K2.5=0

Change the programming.

The main spindle is commanded to rotate when gear is not selected.

Main spindle cooling unit alarm.

Clamp signal is off when Servo Turret is not operating.

Check if the Turret Clamp Sensor works. If the sensor works properly, set the 1st turret by moving it 1 degrees. Adjust the MILL SPINDLE ORIENTATION position.

Servo Turret is not clamped again in 5 seconds after it is unclampled.

Check if the turret is in position to clamp. Reset it, manually move it to position, and check if the position it right. When manual adjustment is impossible, Servo Turret adjustment is needed. If Turret is clamped, check the clamp sensor.

M45 commanded but the spindle gear is not at 1st stage.

Command M41 before M45 in cycling program.

DOOR INTERLOCK RELEASE KEY S/W is ON.

Turn off the DOOR interlock release key S/W.

Signal is detected from FILTER PRESSURE S/W of COOLANT UNIT.

Remove anything that blocks filter.

Signal is detected from INLET PRESSURE S/W of COOLANT UNIT.

Check the Coolant unit.

Chuck pressure decreased during Main Spindle rotation.

Check the pressure of hydraulic pump.

Chuck pressure decreased during Sub. Spindle rotation.

Check the pressure of hydraulic pump.